Taheri Enterprises

• Seamless Electrical Gloves

• Soft and flexible4

• Brands:-Crystal,Regeltex

• Class00,Class I,Class II,Class III and Class IV available

Additional Information:

• Item Code: TE-PPE-5002

• Super soft thermoplasatic provided unrivaled comfort
• Tested to over 40 autoclavable cycles
• Toughened anti scratch polycarboate lens
• Indirect base ventilation
• EN approved

• Once the top layer is dirty, simply remove and discard.
• Cleanroom sticky mats offer economical dirt and dust control for low-profile carpet, tile and concrete surfaces.
• These clean room tacky mats are ideal for hospital, laboratory and construction use.

Additional Information:

• Item Code: TE-PPE-7016

Autoclavable Spray Bottles:

• Stainless Steel Cylinder
• To prevent deformation by heat, using high precision stainless steel cylinder.
• Piston And Piston Shaft is made of heat-resistant resin.
• Piston Gasket is also heat resistant and abrasion resistant material.
• Compact design easy to hold.

Usable Chemicals:

• Etanol, Isopropyl Alcohol, 0.2% benzalkonium chloride.
• 0.2% Alkyldiaminoehylglycine hydrochloride, 0.05% chlorhexidine gluconate.
• 0.2% acrinol, iodine disinfectant, WFI, Deionized water, boiled water, neutral chemicals.
• [Note] Some chemicals may remove the oil of cylinder.

Unusable Chemicals:

• Cresol, Oxydol, Sodium Hypochlorite Solution, Viscous liquid, Aldehyde-based disinfectant, organic solvent.

• Pump and bottle is to be autoclaved separately.
• Not to be autoclave when it content any chemical.

• Convenient to use, the Sticky Roller is quick and effective at removing various contaminating particles from floors, ceilings, walls, table tops and other surfaces.

• The concept is similar to the common paint roller; a roller handle with cover.

• The cover in this case is a roll of adhesive coated substrate that has removable sheets

• Kosan sticky roller is very easy to use; just roll the area to be cleaned as if you were painting the wall.

• When the roller becomes too soiled to pink up any more contaminants, simply peel off the soiled layer and tear off at the perforations to expose a new sheet of adhesive films.